Applies to: All CO2 machines, on a Mac
Install the free trial of LightBurn on a Mac and create your machine as a device, so you are ready before your laser arrives.
What you need
- Apple computer
- Internet connection
Install the software
-
Download LightBurn to your computer. LightBurn runs on macOS 10.11 or later.
-
Double-click the LightBurn.dmg file to mount the disk image.
-
Drag the LightBurn application into your Applications folder, then double-click the LightBurn icon to begin.
If LightBurn will not open because it cannot be verified
-
Click Cancel.
-
Click the Apple logo, then click System Preferences.
-
Click Security & Privacy.
-
Click Open Anyway.
-
Click Open.
Start the trial and create your device
-
Click the Start Your Free Trial button, and click OK.
-
Click Ruida, and click Next.
-
Click Serial/USB, and click Next.
-
Enter the X Axis Length and the Y Axis Length of your machine in mm. Click Next.
Find the X and Y axis length of your machine 
-
Set the origin by clicking Rear Right. Click Next.
-
Check that everything is correct and click Finish.
-
Click OK.
LightBurn is now set up. Once your machine arrives, follow LightBurn Setup: After Your Machine Arrives (Mac).
Need a hand?
Email support@aeonlaser.us or call 321-260-2325. More ways to reach us are on the Support page.