Applies to: MIRA 9
How to remove the exhaust fan from a MIRA 9.
Warning: Turn the machine off and unplug it before you start.
What you need
- Phillips screwdriver
- Cabinet key
- Allen key set
Remove the fan
-
Use the cabinet key to open the lower right panel on the back of the machine.
-
With a Phillips head screwdriver, loosen the duct hose clamps and remove the hose from the fan and from the back of the machine.
-
Unscrew the four bolts that hold the fan to the cabinet floor.
-
Follow the two wires marked “Fan” to the lever DIN connectors. Flip up the orange lever to release each wire, and gently pull the wire out of the connector.
-
Follow the green and yellow ground wire from the fan to the ground bar. With a Phillips head screwdriver, disconnect the ground wire from the ground bar.
-
Lift the fan up and out of the cabinet.
Need a hand?
Email support@aeonlaser.us or call 321-260-2325. More ways to reach us are on the Support page.