Applies to: MIRA 5, MIRA 7 and MIRA 9 (Legacy), and NOVA 10, NOVA 14 and NOVA 16 (Legacy)
This guide shows how to read the firmware version and the HMI version of your laser from its screen as the machine starts up. It takes about a minute.
Your laser shows both version numbers on its screen every time it starts up. They tell our support team exactly which software your machine is running, so we may ask you for them when you open a ticket.
Have a REDLINE MIRA S or NOVA S? Its screen shows the versions in a different place. Use our guide How to Find the Firmware and HMI Version: REDLINE MIRA S and NOVA S instead.
What the two versions are: The firmware is the software on the controller, the board that runs your laser. The HMI (human-machine interface) is the control panel: the screen and its keypad. Each has its own version number.
What you need
- No tools: everything is read from the screen of your laser
- The laser switched off to begin with: the versions show only as it starts up
- A phone to photograph the screen: optional, but it makes the numbers easy to read back
- About one minute
Read this guide all the way through before you start. The steps follow the way our own technicians check the versions.
1. Start up the laser
If the laser is on, make sure no job is running or paused, then switch it off. Wait a few seconds.
-
Check the work area, then switch the laser on.
Caution: The laser head moves to its home position as the machine starts up. Before you switch the laser on, make sure nothing inside the cabinet is in its way.
-
Watch the lower right of the screen. The screen lights up and shows Connecting to controller... for a few seconds, then the main screen appears. A moment later three lines of text show in the box at its lower right, below the X, Y and Z positions.

The main screen as the laser starts up. The box with the three lines, outlined in red, is at the lower right.
2. Read the two versions
The second and third lines are the two version numbers. The numbers on your machine may be different from the ones shown here. They stay on the screen only while the laser is starting up, so read them straight away.

| On the screen | What it tells you |
|---|---|
| System Resetting | The laser is starting up and moving the laser head to its home position. |
| RDC-V8.01.70 | The firmware version of the controller. |
| HMI-V2.4.59.05 | The HMI version: the version of the screen and keypad. |
| Esc | Shown at the bottom of the box. Pressing the Esc key now would cancel the reset, so leave the keypad alone. |
Write down the RDC line and the HMI line exactly as they appear, or take a photo of the screen with your phone. If you miss them, switch the laser off, wait a few seconds and switch it on again: they show every time the laser starts up.
Let the laser finish starting up. Do not press any keys until the laser head has stopped moving and the lines have cleared from the screen.
You now have the firmware and HMI version of your laser. Include both when you open a support ticket. If the lines do not show on your machine, or you cannot read them, send us a photo or a short video of the screen as the laser starts up. It helps our technicians help you faster.
Need a hand?
Email support@aeonlaser.us or call 321-260-2325. More ways to reach us are on the Support page.