Applies to: MIRA 9
How to remove the internal chiller from a MIRA 9. To prevent water damage, remove the chiller before you turn the machine on its side to move it through stairways, hallways and doorways.
Warning: Turn the machine off and unplug it before you start.
Caution: Drain the chiller completely before you remove it.
What you need
- Phillips head screwdriver
- Cabinet key
- Masking tape
- Towel
- Wire cutters or scissors
- Bucket
Remove the chiller
-
Open the lower panel on the right side of the machine. Find the side of the chiller at the right end of the opening.
-
Unplug the power plug from the chiller by gently pulling it out. Remove the signal wire by unscrewing its retaining ring and then pulling it out.
Use a cabinet key to open the exhaust system access panel on the back of the machine. Find the side of the chiller, on the left, and the two silicone hoses that connect to the chiller inlet and outlet.
-
Wrap a piece of masking tape around one of the hoses, and put a second piece of tape on the side of the chiller where that hose connects. This marks which fitting the hose belongs to, so both hoses are reconnected correctly.
-
Using small wire cutters, clip the zip ties that secure the hoses to the chiller. Do this at the chiller end of the hoses, not the machine end. Gently pull the hoses off the chiller inlet and outlet, with a towel or bucket ready to catch any water.
-
Remove the 4 Phillips head screws that hold the chiller in the machine, one at each corner of the rear panel of the chiller.
-
Gently slide the chiller out of the machine. Use the open side panels to guide it carefully out of the back.
Need a hand?
Email support@aeonlaser.us or call 321-260-2325. More ways to reach us are on the Support page.