CO2 Laser Frequency Settings: How to Test for Better Cuts

The Setting Most People Skip

When your laser results aren’t quite right, you probably adjust power or speed. There’s another setting worth understanding: frequency. In this episode of Tech with Lek, AEON’s Chief Technology Officer explains what frequency changes and how to test it for better results.

The short answer: Frequency controls timing, and timing can change your result. Don’t choose a number just because it’s higher. Test it, compare it, and record what works.

01

What the Frequency Setting Controls

The frequency setting controls the timing of the laser’s on-off command. It doesn’t change the beam’s wavelength.

Changing frequency is possible on nearly every laser. The demonstration in this episode sticks with RF lasers.

02

Hertz and Kilohertz

Hertz means cycles per second. Kilohertz means thousands of cycles per second. So 20 kHz is 20,000 pulses per second, and 100 kHz is 100,000 pulses per second.

Lower frequency fewer, longer pulses Higher frequency more, shorter pulses the same length of time
Both charts cover the same time at the same duty cycle. Illustrative; real pulse counts are in the thousands per second.
03

Duty Cycle: How Long the Command Is On

Duty cycle means the percentage of time the command is set to on. At the same duty cycle, increasing frequency shortens each on period. It doesn’t automatically add power.

The tube’s response rate also affects the actual light output, so changing frequency can change what reaches the material even when the power percentage stays the same.

04

The Three-Shape Frequency Test

  1. Prepare three identical test shapes on your material.
  2. Start with your manufacturer’s recommended settings.
  3. Compare a lower baseline and a higher frequency, all within the approved range.
  4. Keep speed and power the same so frequency is the only thing that changes.
  5. Record what works.

In the episode, Lek compares 4 kHz, 20 kHz, and 60 kHz at the same speed and power.

4 kHz 20 kHz 60 kHz same shape, same speed, same power
The test layout from the episode: only the frequency changes.
05

What to Look For

  • Acrylic cutting: a higher frequency can produce a smoother edge.
  • Wood cutting: a lower frequency can sometimes reduce charring.
  • Engraving: compare detail, contrast, and depth.

Those are directions to investigate, not guaranteed results. A lower frequency doesn’t automatically mean less heat.

06

Think of It as Hammer Hits

Low frequency is like hitting the material with a sledgehammer fewer times per second. Higher frequency is like a small hammer hitting many times per second.

07

Frequently Asked Questions

Does a higher frequency mean more power?

No. At the same duty cycle, a higher frequency shortens each on period. It doesn’t automatically add power.

Does changing frequency change the laser’s wavelength?

No. The setting controls the timing of the laser’s on-off command, not the wavelength of the beam.

What frequency should I use for acrylic or wood?

There is no single number. A higher frequency can give acrylic a smoother cut edge, and a lower frequency can sometimes reduce charring on wood. Test on your own material within the manufacturer’s approved range.

Does a lower frequency mean less heat?

Not automatically. Changing frequency can change the actual output even when the power percentage stays the same, so compare real samples.

What does 20 kHz mean?

20,000 pulses per second. Hertz means cycles per second, and kilohertz means thousands of cycles per second.

More From Tech with Lek

Each episode tackles one laser topic. Have a question for Lek? Leave it in the comments on the video.