Applies to: MIRA 7 and MIRA 9
How to replace a motor driver in a MIRA.
Warning: Turn the machine off and unplug it before you start.
What you need
- Cabinet key
- Screwdriver
- New driver
Replace the driver
-
Open the lower right side panel with the cabinet key, and find the drivers.
-
Gently pull the green terminal blocks from the driver. Let the wires and terminal blocks hang out of the way.
-
With a screwdriver, remove the screw at the top of the driver and set it aside. Loosen the screw at the bottom of the driver. You do not need to remove it. Lift the driver out.
-
Seat the new driver on the loosened bottom screw. Refit the top screw and tighten it, then tighten the bottom screw to secure the driver.
Plug the green terminal blocks into the new driver.
Close and lock the right panel door.
Need a hand?
Email support@aeonlaser.us or call 321-260-2325. More ways to reach us are on the Support page.