Knowledge Base
Repair
Guides, videos and manuals for your AEON laser.
Replace a Driver: MIRA
Swap a motor driver in a MIRA 7 or MIRA 9: unplug the terminal blocks, change the driver and plug them back in.
Read Guide →Replace the 24V Power Supply: MIRA
Replace the 24V power supply in a MIRA and set the new unit to 115V before fitting it.
Read Guide →Replace the 40V Power Supply: MIRA
Replace the 40V power supply in a MIRA, which sits behind the 24V supply, and set the new unit to 115V.
Read Guide →Replacing the Auto Focus Pin
Swap a bent or sticking auto focus pin on a MIRA, and check that the sensor light comes on afterwards.
Read Guide →Solenoid Retrofit: MIRA 9
Fit the new solenoid valve body to a MIRA 9 and reconnect its three air lines.
Read Guide →Chiller Flow Sensor Replacement
Replace a failed chiller flow sensor: remove the old one, fit the new one the right way round and join the wires with solder se...
Read Guide →Drive Belt Replacement: MIRA and NOVA
Replace the X or Y drive belt on a MIRA or NOVA, check the tension, then tune the scanning offset settings in LightBurn.
Read Guide →Still Stuck? Call (321) 260-2325
Our US-based support team is one phone call away. More ways to reach us are on the Support page.