Applies to: MIRA 5, MIRA 7 and MIRA 9 (Legacy), and NOVA 10, NOVA 14 and NOVA 16 (Legacy)
This guide shows how to delete every job file stored on your laser’s controller, using the keypad on the machine. It takes about a minute.
Job files that you send to your laser, or copy to it from a USB drive, are saved in the controller’s memory. Over time they build up: the file list gets long, and the controller can run out of room for new jobs. Clearing the memory removes them all at once. Only job files are deleted; the settings of your machine are not changed.
Warning: This cannot be undone. These steps permanently delete every job file stored on the controller. The design files saved on your computer are not affected, so make sure you still have the original of anything you will want to run again.
What you need
- No tools: everything is done on the keypad of your laser
- The laser switched on and idle, with no job running or paused. The bottom left corner of the screen reads Idle
- About one minute
Read this guide all the way through before you start. The steps follow the way our own technicians clear the memory.
Get to know the control panel
Everything in this guide is done on the control panel: the screen, and the keypad below it. You only need the keys highlighted in the diagram: File, Enter and Esc on the right of the keypad, and the four arrow keys in the middle.


1. Open the Other+ menu
-
With the laser switched on and idle, press File. The files stored in the controller’s memory are listed on the left of the screen, with a menu beside them.

After you press File, the files in the controller’s memory are listed on the left. -
Use the arrow keys to highlight Other+: press the right arrow to move across to the menu, then the down arrow until Other+, the third item, is highlighted.

Other+ is highlighted. Press Enter to open it. Press Enter. The Other+ menu opens.
2. Delete all files
-
Press the down arrow until del all mem file, the third item, is highlighted.

Highlight del all mem file, then press Enter. Note: Only del all mem file is needed. Leave the other items in this menu alone unless a technician asks you to use them.
-
Press Enter. Every file is deleted straight away, with no second prompt, and the message Delete Successful appears on the right of the screen.

Delete Successful confirms that the files have been deleted. Press Enter again to clear the message.
3. Check that the memory is clear
Press Esc to go back to the file list.
-
Check the list on the left of the screen. It is now empty.

The file list is empty once the memory has been cleared. Press Esc again to return to the main screen.
The controller’s memory is now clear and ready for new jobs. If files are still listed after you follow these steps, or the laser shows an error message, open a support ticket and tell us what you see. A photo of the screen helps our technicians help you faster.
Need a hand?
Email support@aeonlaser.us or call 321-260-2325. More ways to reach us are on the Support page.